I have a kohler swiftflo bath drain k 11677.
Trip lever drain stopper not working.
Unscrew the cover plate from the front of the bathtub using a screwdriver.
This is a perfect application for those products.
Push the assembly back in and replace the.
When the stopper in your lever style bathtub drain won t pop up anymore because the linkage is damaged or clogged replace it with a much simpler lift and turn style tub drain.
You may also try spraying a little wd40 or pb blaster on the lever bar so it runs down the whole mechanism to try and break some of that corrosion free.
When the trip lever is moved to the closed position gravity allows the stopper to drop back down and seal the drain opening.
The stopper will not work and the trip lever will not go up.
It s usually held on by two.
The trip lever in my bathtub is stuck step 1.
How to repair the trip lever in a tub drain 1.
The lubrication may help to.
Try spraying some liquid wrench or wd 40 down the overflow drain pipe where to plunger sits.
Use pliers to.
Next spin the adaptor that the plunger hangs from down until it reaches the bottom lock nut and then tighten the upper locknut to the adaptor.
Problems with this type are usually signaled when the pop up stopper fails to push up enough to open the bathtub drain it wants to stay in the closed position constantly.
Remove the two screws securing the lever faceplate to the tub with a phillips head screwdriver.
You don t require long term lubrication you just need to free a stuck part.
Straighten the end of.
Pull the plate and lever away from the overflow hole partially pulling out the mechanism.
To lower the stopper thread the bottom lock nut down.
Removing this clip will allow you to detach the.
The linkage in a lever style drain attracts dirt and hair like a magnet and must be cleaned regularly in order to keep the drain working properly.
On the end will be a.
Place a towel or rag over the bathtub drain to prevent dropping screws down the drain accidentally.
I have unscrewed the overflow hood and tri read more.
Pull the lever out then lift it straight upward to remove the linage from behind the tub.
The lever seems to be stuck in the down position.
Excavate for the plug or.
Remove the screws that secure the overflow cover plate.